Follow these steps to connect your Woojer Strap Edge to your receiver/amplifier. There are several options to connect the Woojer Strap Edge to your receiver/amplifier. You can choose between a wired connection with an aux cable using the receiver/amplifier integral Bluetooth or using an external Bluetooth transmitter.
When using Bluetooth, remember that once completing the pairing process, the Woojer Strap Edge will automatically remain connected when turned on.
Important: Always set your system volume to high/max, to ensure maximum effect. To control the headphones and sensation levels - use the Woojer Strap Edge's control buttons.
Using 3.5mm cable connected to the receiver/amplifier
- Press and hold the Woojer Strap Edge's power button for 2 seconds until the Woojer Strap Edge turns on.
- Connect the provided 3.5mm aux cable - one end to the receiver/amplifier line-out jack and the other to the Woojer Strap Edge's audio input jack. The blue LED will appear constantly.
- Connect your headphone to the Woojer Strap Edge's headphone jack.
Using receiver/amplifier integral Bluetooth connection
- Enter pairing mode by pressing the Woojer Strap Edge's Power button for 5 seconds. The blue and red LEDs will blink alternately.
- On your receiver/amplifier, enter pairing mode and locate Woojer Strap Edge.
- Pair and connect the Woojer Strap Edge with your receiver/amplifier. The blue LED will illuminate constantly.
- Connect your headphone to the Woojer Strap Edge's headphone jack.
Using an external Bluetooth transmitter
For this type of connection, you will need an external Bluetooth transmitter.
- Connect the transmitter to your receiver/amplifier by using either a 3.5mm cable or by using a digital audio cable (S/PDIF)
- Pair your Woojer Strap Edge with the Bluetooth transmitter: Enter pairing mode by pressing the Woojer Strap Edge's Power button for 5 seconds. The blue and red LEDs will blink alternately. Refer to the transmitter manual for detailed pairing information.
- Connecting your headphones: You can connect wired headphones directly to your Woojer Strap Edge. Alternatively, if your Bluetooth transmitter is a dual-link one, you can pair both the Woojer Strap Edge and your Bluetooth headphones, concurrently.
- If your Bluetooth transmitter is a dual-link one, you can pair two Woojer Strap Edge units at the same time. In this case, connect each one of them to wired headphones.
Here are some examples of low-latency Bluetooth transmitters:
Avantree low-latency, dual-link Bluetooth transmitter, with S/PDIF input